Filmora13(フィモーラ13)のおすすめ初期設定方法まとめ

In this article.Filmora13This section describes the recommended initial setup method for the

Filmora13(フィモーラ13)の初期設定方法

After opening Filmora's editing window, click on "File" at the top of the screen and then click on "Settings.

A screen called "Settings" will appear.

General Settings

appearance

[If you click on the "Appearance" item, you can choose between "Dark Mode" and "Light Mode".

It is currently in dark mode, so I will try setting it to light mode.

As you can see, the editing screen changes to a brighter state, so you can set it according to your preference.

message center

This section refers to the message screen that appears when you start Filmora, which some people may find annoying because it appears every time there is a new message.

[If you check the "Do not show messages automatically" checkbox, the message center will not appear automatically.

Project library window at startup

This is the screen that appears when Filmora is launched, before the editing screen appears.

Note, however, that if you have not saved the data for the editing project, it will not be displayed.

On this screen, you can set the aspect ratio, create a new project, directly open the data of a saved editing project, or click on each tool to start editing immediately.

Check this box if you want this project library window to appear at startup, or uncheck it if you do not need it.

Preservation Settings

[Under "Save", make sure that "Back up project every time" is checked and set the time to "5 minutes".

This function automatically backs up the data that has been edited so far, and it is already set up by default, so it is much safer, but it is a very important setting, so please check it.

If there is no backup, your edits will be lost and you will have to start over, unless you save the edited project yourself.

Performance Settings

[Under "GPU," check "Enable hardware acceleration when rendering and playing back video" and "Enable hardware acceleration when decoding video.

Note that this setting is not available if the PC you are using does not have a GPU.

With this setting, the GPU also performs processing when outputting as video, when playing back in preview during video editing, and when importing recorded video into Filmora, resulting in faster processing speeds and a more responsive operation.

Next, there are other settings that may be required in some situations, but click "OK" as this is all you need to do for the important initial settings.

Since you have just changed the GPU item settings, you will see a warning screen that Filmora must be restarted to take effect.

[Clicking "OK" will close the settings screen, so as mentioned in the previous cautionary screen, restart Filmora once before editing.

ここで、Filmora13(フィモーラ13)の初期設定は完了です。

summary

In this article.Filmora13The recommended initial setup method for the